Senco 1 gallon finish & trim air compressor is designed with the
professional contractor in mind: compact, lightweight hand carry,
sturdy, powerful, oil-free, 102 second pump up time, 27 second
recovery time, low maintenance and warrantied. Our compressor
truly makes hard work easier. The PC1010N is lightweight at just
21 lbs. (9.53 kg), and its compact design measuring 14x13x10
ensures easy portability to any jobsite. The gauges on our
control panel are easy to read and the integrated control panel
is designed for easy access and straightforward operation. In
addition, the PC1010N features an ultra-quiet 68 dBA noise level
of operation – A standard Garbage Disposal is louder – and a
rugged, rust-resistant, aluminum design. Every contractor and DIY
enthusiast will agree this is an ideal “finish and D6 trim unit”
for finish trim nailer, pin nailer and more – especially since
its ¼” coupler is a universal design. That makes it compatible
with a variety of air tools from all of the top manufacturers.
The long life induction motor and oil free pump eliminate the
need for oil and regular maintenance. Its direct drive pump/motor
offer efficient operation. There are numerous safety features
included in the design of the PC1010N. For example, the
motor/pressure switch has a pressure release valve that
automatically releases compressed air from the air compressor
pump head and its discharge line when the air compressor reaches
cut-out pressure or is shut off - allowing the motor to restart
freely. Also, the motor has a protective Breaker on the pump
which trips if there is an excessive Amperage draw - protecting
both the operator and the motor itself. The air intake filter
doesn't need to be replaced; It is reusable and should always be
clean with its ventilation opening free from obstructions. It can
be cleaned by using warm, soapy water and then rinsed and set out
to air dry. Further, there is a safety valve designed to
prevent system failures by relieving pressure from the system
when the compressed air reaches a predetermined level. Having
been preset by the manufacturer, it should not be modified in any
way. Additionally, the air tank drain valve is used to remove
moisture from the air tank after the compressor is shut off.
Never attempt to open the drain valve when more than 10 PSI of
air pressure is in the tank. To open the drain valve, turn the
knob counterclockwise then tilt the tank to ensure that all
condensation drains through the valve. Additional features can be
seen in detail in the user manual, included in the packaging. The
power cord included with this unit is 6 feet long. If additional
length/distance is needed, Senco recommends using one of our 50’
or 100’ proFlex or push on ¼” air hoses – available on – instead
of an extension cord. If use of an extension cord is unavoidable,
it should be plugged into a GFCI found in circuit boxes or
protected receptacles. If use of an extension cord is
unavoidable, refer to our operating manual and observe the
recommended cable Length and wire Gauge listed. Additionally, use
only 3-blade extension cords that have 3-blade grounding-type
plugs and 3-slot cord connectors that will accept the plug from
the PC1010N. Use only extension cords having an electrical rating
not less than the rating of the product.
- 1-GALLON TANK & MAX PRESSURE OF 135 PSI - less than 2 minutes to pump up and less than 30 seconds of recovery. Perfect for finish & trim work on the job and hobbies & crafts at home.
- OIL-FREE - requires virtually no maintenance and lets you work in a cleaner air environment compared to legacy cast iron, belt driven, oil lubricated compressors.
- QUIET MOTOR - provides all the power you need for finish jobs, with significantly less noise than traditional compressors.
- COMPACT DESIGN - 14"x13"x10" makes it easy to hand carry and load onto a truckbed or back seat for any number of finish jobs.