Zepofit Gym Machine Cable Ball Stopper Replacement, Duarable Ball Stop for Cable Machine Use Lifting Cable

How to install the ball stopper?

This ball stopper uses with a new cable mostly.

▶ For a new cable, use cable to go through the hole of ball (and set other parts in right position if there are), peels a small section of plastic cover (if there is) of the cable. when connect it to a metal eyelet terminal, use a hydraulic crimper (plier) tool to squeeze the connecting part.
if you don't use a eyelet terminal, but make the cable with a loop end, you can use a wire rope clamp or crimping loop sleeve on the cable to fasten it. you need a spanner or hydraulic crimper to process it.

▶ For an old cable, firstly you need to cut off the end of the cable (where there is a eyelet or loop terminal), then use cable to go through the hole of ball (and set other parts in right position if there are), and process it just same as a new cable we mentioned above.

Q&A from users

• - Q: How to install the ball stopper?
  
• - A: This is mostly for use with a new cable. The cable has to be went through the hole of the ball. Since most cables have loops at their ends, to install this on a cable that's already in service, you'd have to cut the loop off. But then the cable wouldn't be serviceable. You can get the cable and end-fittings from Home Depot, so replacing most cables is pretty easy.
  
• - A: In my case, I had to remove the existing cable from the machine by unbolting the cable from where it was attached to the frame. I then threaded the new rubber stopper onto the cable and then ran the cable through the pulley system and back to where I had removed the cable from the frame of the machine.
  

• [SIZE DIMENSION] the ball is 38mm Diameter. 10mm hole..
• [DURABLE MATERIAL] Use high quality hard nylon material, good impact-resistant performance. factory mass-produced product, with standard and qualified procedure..
• [APPLICATION] This cable stopper can be used in any occasion where need impact-resistance, shock absorbtion function, with 10mm hole, for any cable thiner than this hole. It could reduce the impact force effectively and protect the equipment, prolong the working life of equipment connected..
• [How to Install] A hydraulic crimper (plier) tool is requested when installing. Mostly use with a new cable. Pass the cable/rope through the hole, then fix the end of the cable with cable clamps or eyelet terminal by the hydraulic crimper. For old cable, you need cut the terminal off before installation, then do same as the new cable.
• [PACKAGE CONTAINS] 2Pcs Ball Stopper. In box packing. [180-DAY GUARANTY] If there is any quality problem with our product, please contact us, we will send new item without extra charges..